Stats

Locked Locked
Replies 1
Subscribers 125
Views 13472
Members are here 0

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

simvision schematic cross probing

Using cross selection we can very easily make the cross-probe of the nets.

using this option the net can be easily highlighted in the SimVision windows(waveform window, ...), but the problem is that the net selected in the waveform window is also highlighted in schematic editor.

Is there any solution to make this option unidirectional, so that only from schematic to waveform function.

Parents

Andrew Beckett over 10 years ago

I don't think so - if I remember rightly, you need to turn on the cross selection in the Editor Options (might be Display Options - I can't check right now) in the schematic editor - and doing so enables the cross-selection in both directions.
Cancel
Vote Up 0 Vote Down

Cancel

Reply

Andrew Beckett over 10 years ago

I don't think so - if I remember rightly, you need to turn on the cross selection in the Editor Options (might be Display Options - I can't check right now) in the schematic editor - and doing so enables the cross-selection in both directions.
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.