Stats

  • Locked Locked
  • Replies 4
  • Subscribers 126
  • Views 13485
  • Members are here 0
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

ADEXL worst corner summary after simulations are done.

vamshiky

Hi,

Is there any way to get a simple summary for some important measurements for min/max and the corresponding PVT corner+design variable.

this would be quite handy for documentation of the results.

Thanks,

Vamshi

Parents

  • Vamshi,

    You should contact customer support - there is an enhancement CCR asking for this (1151615) - so you should request a duplicate CCR to increase the chances of this being implemented sooner rather than later.

    Potentially the information could be found using SKILL code (using axlReadHistoryResDB) but I don't have the bandwidth to write an example at the moment.

    Regards,

    Andrew.

Reply

  • Vamshi,

    You should contact customer support - there is an enhancement CCR asking for this (1151615) - so you should request a duplicate CCR to increase the chances of this being implemented sooner rather than later.

    Potentially the information could be found using SKILL code (using axlReadHistoryResDB) but I don't have the bandwidth to write an example at the moment.

    Regards,

    Andrew.

Children
No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.