• Skip to main content
  • Skip to search
  • Skip to footer
Cadence Home
  • This search text may be transcribed, used, stored, or accessed by our third-party service providers per our Cookie Policy and Privacy Policy.

  1. Community Forums
  2. Custom IC Design
  3. Parasitic extraction problem

Stats

  • Locked Locked
  • Replies 4
  • Subscribers 126
  • Views 18167
  • Members are here 0
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Parasitic extraction problem

PS90
PS90 over 10 years ago

I have made a CMOS based circuit and then developed its layout. The DRC, ERC etc. all shows no error. For parasitic extraction, i have used QRC. Still, no error shows and extraction completed successfully. But, when i see av_extracted view, only parasitics and pins are shown but no layout, because of that i am unable to do post-layout simulations. I am unable to understand this rather strange problem. So, i have attached some images of av_extracted and layout view alongwith the DRC and QRC setting on my setup. Please help in this matter.

  • Cancel
Parents
  • Quek
    Quek over 10 years ago

    Hi Pushkar Srivastava

    I think you had not provided any info on whether there are actual non-parasitic devices in the extracted view. Would you please try the following?

    a. Open up the extracted view
    b. Go to "Launch->ADE L"
    c. Go to "ADE: Simulation->Netlist->Create"

    Do you see any mos devices in the generated netlist?

    Best regards
    Quek

    • Cancel
    • Vote Up 0 Vote Down
    • Cancel
Reply
  • Quek
    Quek over 10 years ago

    Hi Pushkar Srivastava

    I think you had not provided any info on whether there are actual non-parasitic devices in the extracted view. Would you please try the following?

    a. Open up the extracted view
    b. Go to "Launch->ADE L"
    c. Go to "ADE: Simulation->Netlist->Create"

    Do you see any mos devices in the generated netlist?

    Best regards
    Quek

    • Cancel
    • Vote Up 0 Vote Down
    • Cancel
Children
No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.

© 2025 Cadence Design Systems, Inc. All Rights Reserved.

  • Terms of Use
  • Privacy
  • Cookie Policy
  • US Trademarks
  • Do Not Sell or Share My Personal Information