Stats

Locked Locked
Replies 2
Subscribers 125
Views 14682
Members are here 0

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

ADE XL: Limiting the max number of jobs in Local simulation mode?

Hello.

Is there a way to set a hard limit to the max number of parallel jobs in local simulation mode in ADE XL?

I have had situations where I enter a large number (say 50) in "Max. Jobs" in Job Policy Setup and forget to change the Distribution Method from Local to LBS. If I launch simulations with this, my local workstation locks up as all of the memory and CPU resources are taken up and the only solution is hard resetting the computer.

Alternatively, it would be nice if I can set different job policies to testbench debug (single run) and batch simulations.

Thanks

Parents

kentauta over 9 years ago

Thanks, Tom! That works perfectly.
Cancel
Vote Up 0 Vote Down

Cancel

Reply

kentauta over 9 years ago

Thanks, Tom! That works perfectly.
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.