• Skip to main content
  • Skip to search
  • Skip to footer
Cadence Home
  • This search text may be transcribed, used, stored, or accessed by our third-party service providers per our Cookie Policy and Privacy Policy.

  1. Community Forums
  2. Custom IC Design
  3. Assura LVS using: setenv OA_UNSUPPORTED_PLAT linux_rhel...

Stats

  • Locked Locked
  • Replies 10
  • Subscribers 126
  • Views 16114
  • Members are here 0
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Assura LVS using: setenv OA_UNSUPPORTED_PLAT linux_rhel40_gcc44x

bartman
bartman over 9 years ago

I am having an LVS problem and I noticed this post.  I am not sure if anyone is still around (based upon the 2010 responses) to reply.

At the end of the lvs report I have the following message:

Preprocessing layout network phase 2
*ERROR* Device 'pfet(Generic)' on Schematic is unbound to any Layout device.
*ERROR* Device 'nfet(Generic)' on Schematic is unbound to any Layout device.
*ERROR* UnBound devices found.
Info: All devices must be bound or filtered for comparison to be run.
Exiting nvn.

It implies that I have devices in the schematic which cannot be matched to a layout device.  I have tried this in calibre and succeeded in getting a clean LVS; so I know the layout and schematic do match.  I would like to have assura working as well.  One possible issue is in the use of multiplicity; m>1 for every transistor in the schematic.   The LVS checks using assura for devices which have m=1 have worked.  Is it possible to fix this problem ?

alan

  • Cancel
Parents
  • Quek
    Quek over 9 years ago

    Hi Alan

    I totally agree with you that Assura should also give the same LVS match results as Calibre.

    Would you please upload the .cls file (e.g. design.cls) in the run directory? This is the LVS report file.


    Best regards
    Quek

    • Cancel
    • Vote Up 0 Vote Down
    • Cancel
Reply
  • Quek
    Quek over 9 years ago

    Hi Alan

    I totally agree with you that Assura should also give the same LVS match results as Calibre.

    Would you please upload the .cls file (e.g. design.cls) in the run directory? This is the LVS report file.


    Best regards
    Quek

    • Cancel
    • Vote Up 0 Vote Down
    • Cancel
Children
No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.

© 2025 Cadence Design Systems, Inc. All Rights Reserved.

  • Terms of Use
  • Privacy
  • Cookie Policy
  • US Trademarks
  • Do Not Sell or Share My Personal Information