Stats

  • Locked Locked
  • Replies 2
  • Subscribers 125
  • Views 13502
  • Members are here 0
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

How to add Pwr sensitivity to a bus

mbugbee

Using cadence_ic 6.1.6.500.14 I can successfully add Pwr Sensitivity and Gnd Sensitivity to single pins.

However adding Pwr/Gnd Sensitivity to a bus does not work.

I can set the attributes in the properties form, however the value is never kept.

When setting the attribute in the Property editor the value set is immediately cleared.

How can Pwr/Gnd attributes be set for a bus ?

e.g. trim<4:0>

Parents
  • mbugbee
    How should pwr / ground attributes be set of bus pins ?
    e.g. trim<5:0>
Reply
  • mbugbee
    How should pwr / ground attributes be set of bus pins ?
    e.g. trim<5:0>
Children
No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.