Stats

  • Locked Locked
  • Replies 6
  • Subscribers 125
  • Views 14241
  • Members are here 0
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Can i make the design rule check blind to a specific layer?

samer1

I am incorporating a device (memrsitor) in my layout that is not defined in the kit. I was thinking of representing the device by a layer that is not used in my design. However, this layer will have its own design rules that are different from the ones I want to set for my memristor?

So, I was thinking of using a layer that does not affect affect the DRC tool (the DRC does not show an error no matter where it is placed) or make the tool ignore the design rules for a specific layer and use that layer to represent the memristor. Is that even possible?

Any thoughts on that issue will be appreciated. 

Parents
  • Andrew Beckett

    This probably depends on whether you can (or want) to modify the DRC rule deck. If you draw everything on layers the DRC rules know nothing about, you probably don't have to do very much - see your other post Make a copy of the Kit

    Regards,

    Andrew.

Reply
  • Andrew Beckett

    This probably depends on whether you can (or want) to modify the DRC rule deck. If you draw everything on layers the DRC rules know nothing about, you probably don't have to do very much - see your other post Make a copy of the Kit

    Regards,

    Andrew.

Children
No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.