Stats

  • Locked Locked
  • Replies 1
  • Subscribers 125
  • Views 13456
  • Members are here 0
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Using AMS pads on Virtuoso Layout L

dpalomeq

Hi,

I am trying to include AMS pads (process AMS C35B3C3) in my layout but I am getting the BAD_SUBSTR_SUBTAP_FLOAT_ERC error when running Assura DRC. Regarding the pins, I am using the PIN PAD layer and I am naming the power and ground pins "vdd3r!" and "gnd3r!", respectively.

Why am I getting this error?

Thanks in advanced!

Regards,

David.

Parents
  • Andrew Beckett

    David,

    You should include the specific AMS process variant you're using - maybe somebody familiar with that process will be able to advise you. I'm not, so I can't, but others might if you give them enough information.

    Kind Regards,

    Andrew.

Reply
  • Andrew Beckett

    David,

    You should include the specific AMS process variant you're using - maybe somebody familiar with that process will be able to advise you. I'm not, so I can't, but others might if you give them enough information.

    Kind Regards,

    Andrew.

Children
No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.