Stats

Locked Locked
Replies 4
Subscribers 135
Views 16522
Members are here 0

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

How the simulation performance mode :APS support the stimulus files?

Dear all,

When I have a stimulus file, I can run well with the simulation performance mode: spectre. After running I can plot all the waveform. But when I use the simulation performance mode: APS, I can't plot the signal waveform in the stimulus file after running. The net in the stimulus file I write: ([#...] 0).

Top Replies

Quek over 7 years ago +1

Hi nnIt Would you please check if COS article 20444507 can help to resolve your problem? You can either save those signals explicitly (e.g. save mySig1 mySig2) or add -rmdg as one of the userCmdLineOption…

Parents

nnlt over 7 years ago

hi quek

thank you very much
Cancel
Vote Up 0 Vote Down

Cancel

Reply

nnlt over 7 years ago

hi quek

thank you very much
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.