Stats

  • Locked Locked
  • Replies 2
  • Subscribers 125
  • Views 14130
  • Members are here 0
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Differential STB analysis in Explorer

Victor Koren

In explorer I dont find the option of using differential STB probes. I had the option in ADE L.

Parents
  • Andrew Beckett

    You need to probe an instance of diffstbprobe in your schematic - then you'll get the option on the form to pick the common-mode or differential-mode stability. The behaviour is the same between ADE L and ADE Explorer - you had to probe a diffstbprobe in ADE L too.

    Andrew.

Reply
  • Andrew Beckett

    You need to probe an instance of diffstbprobe in your schematic - then you'll get the option on the form to pick the common-mode or differential-mode stability. The behaviour is the same between ADE L and ADE Explorer - you had to probe a diffstbprobe in ADE L too.

    Andrew.

Children
  • Victor Koren
    in reply to Andrew Beckett

    Thanks Andrew.
    My memory not as good as it was once...

    Victor

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.