Stats

  • Locked Locked
  • Replies 3
  • Subscribers 126
  • Views 15935
  • Members are here 0
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Running Monte Carlo simulations on a statistical corner in ADE XL

ddsab

Hi, 

I am attempting to run a mismatch only Monte Carlo simulation on a statistical corner in ADE XL on ICADV12.3, but I get the following error:

"ERROR (ADEXL-1751): The 'Monte Carlo Sampling' run mode requires at least one corner other than statistical corners to be enabled for tests." 

What I am trying to do is take my two worst case corners from a process only Monte Carlo simulation, create two statistical corners, and then run mismatch only Monte Carlo on those corners to observe the overlap.  Is it not possible to run monte carlo on a statistical corner? Or do I have to dig through the weeds and create a fixed corner model file from the parameters in my worst case corner?  Any information is greatly appreciated. 

Cheers,

Daron

Parents
  • Sajith Sasidharan

    Hello Daron,

    I am in need of the exact requirement as above. Please advise on any pointers.

    Regards,

    Sajith 

  • Andrew Beckett
    in reply to Sajith Sasidharan

    Hi Sajith,

    This is still not possible, so I doubt Daron would be able to give you any pointers.

    Andrew

Reply
  • Andrew Beckett
    in reply to Sajith Sasidharan

    Hi Sajith,

    This is still not possible, so I doubt Daron would be able to give you any pointers.

    Andrew

Children
No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.