Stats

Locked Locked
Replies 1
Subscribers 125
Views 13085
Members are here 0

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Two part functional symbol in Virtuoso

Hi,

Does Virtuoso have method to support two part symbols? An example would be a relay with a switch and control symbol that is separated but bound to one functional model. This is supported in Allegro PCB designer.

Parents

Andrew Beckett over 5 years ago

Not currently. There's some work under way to support split symbols, but it would be best if you contact customer support so that we can ensure your needs are covered by the implementation work going on.

Regards,

Andrew.
Cancel
Vote Up 0 Vote Down

Cancel

Reply

Andrew Beckett over 5 years ago

Not currently. There's some work under way to support split symbols, but it would be best if you contact customer support so that we can ensure your needs are covered by the implementation work going on.

Regards,

Andrew.
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.