Stats

Locked Locked
Replies 3
Subscribers 125
Views 1666
Members are here 0

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

To be able to print the "region" DC operating parameter of all the transistors in the design

Hi All,

wish to request guidance on how to use AD-EXL expressions to be able to print the "region" DC operating parameter of all the transistors in the design in the output after DC simulation.

If there is any other method for this then I can try that as well.

I am using IC6.1.8

Any suggestions will be great help !

REGARDS

Parents

ShawnLogan over 4 years ago

Dear sidm,

Have you seen this document?

support.cadence.com/.../ArticleAttachmentPortal

Page 32 and forward discusses the different techniques to print operating point parameters. "Region" is one of the operating point parameters as it indicates in the beginning of the document. I hope this helps!

Shawn
Cancel
Vote Up 0 Vote Down

Cancel
sidm over 4 years ago in reply to ShawnLogan

Thanks for the information Shawn.
Cancel
Vote Up 0 Vote Down

Cancel
ShawnLogan over 4 years ago in reply to sidm

Dear sidm,

sidm said:
Thanks for the information

Sure! I hope it provides the insight you need!

Shawn
Cancel
Vote Up 0 Vote Down

Cancel

Reply

ShawnLogan over 4 years ago in reply to sidm

Dear sidm,

sidm said:
Thanks for the information

Sure! I hope it provides the insight you need!

Shawn
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.