Stats

  • Locked Locked
  • Replies 1
  • Subscribers 125
  • Views 9631
  • Members are here 0
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

recognize paths with metal jumps using DIVA

strotta

I have some devices that should be connected through a single metal connection:

Is there any easy way to detect that situation (right) using DIVA?

  • My guess is that probably using the drcAntenna command in Diva would be the way to check this. That said, I'm rather rusty with Diva (despite many years of supporting it, I've not done my with Diva for a long time) and this is a slightly unusual requirement. It seems to be it is close to an antenna-type check requirement.

    Perhaps worth reading that part of the Diva Reference manual?

    Andrew

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.