Stats

Locked Locked
Replies 2
Subscribers 125
Views 5563
Members are here 0

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

[Solved] Cannot Direct Plot PAC Current (Even though it is saved in outputs!)

Hi,

I cannot direct plot the output the drain current of a transistor in my PAC analysis. This is while I can plot the voltage of the same node, and I have added the corresponding node as output and selected the save option.

I get the "Error: ...... is not a kept output" error.

Best,
Mahdi

Parents

Andrew Beckett over 1 year ago

Mahdi,

Set useprobes to yes on the Outputs→Save All forum:

You should also think about moving to ADE Explorer (you're using ADE L) since ADE L is obsolete. That won't address this issue, but I just noticed that you're using ADE L and thought I should point it out.

Andrew
Cancel
Vote Up +1 Vote Down

Cancel
MahdiMohammadi over 1 year ago in reply to Andrew Beckett

Thank you, Andrew! It works now.
Cancel
Vote Up 0 Vote Down

Cancel

Reply

MahdiMohammadi over 1 year ago in reply to Andrew Beckett

Thank you, Andrew! It works now.
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.