Stats

  • Replies 1
  • Subscribers 125
  • Views 1481
  • Members are here 0

Process Corner Simulation

CS27

Hi, I'm trying to optimize my circuit to pass certain bandwidth and gain specifications under all corners tt, ss, ff, sf, and fs. I was wondering if there is a way to simulate all 5 of these at one time to see if any one design passes my tests for each corner.

Thank you!

  • Hi,

    All you need to do is set up the Corners under ADE Explorer or Assembler. You can add one corner and configure like the following:

    This will create the 5 process corners you are looking for at once (once you create you will just need to expand to see them).

    I hope this helps.

    Regards,

    Alonso

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.