Stats

  • Locked Locked
  • Replies 2
  • Subscribers 91
  • Views 938
  • Members are here 0
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

How to route additional cells after normal P&R

Sirrius

 Hi All

My job involves taking a routed design and changing some of the cells and routing them to the cells that already exist.

I looked at some ways, and the most obvious way is to manually "Add Wire" option in Encounter. Is there any way to tell the routing tool built in (like sroute) to route the cell for me? For example, I would like to route (or connect) a cell MY_CELL1/PortA (where PortA is the port of this cell) to MY_CELL2/PortB.

Can I use sroute? If yes, then, can someone please throw a hint as to how?

Any other method? I am sure that some method should exist, which should avoid manual "Add Wire" method.

 

Would appreciate any help!

 

Thanks

Parents

  • Bob,

     Thanks for your advise. After tinkering around a bit, I was able to run ECO process. It was a tad tricky, since I was using an older verion of Encounter, which did not have "ecoDesign"

     

    Thanks again!

     

    Regards

     

    Sirrius

Reply

  • Bob,

     Thanks for your advise. After tinkering around a bit, I was able to run ECO process. It was a tad tricky, since I was using an older verion of Encounter, which did not have "ecoDesign"

     

    Thanks again!

     

    Regards

     

    Sirrius

Children
No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.