Stats

  • Locked Locked
  • Replies 2
  • Subscribers 91
  • Views 738
  • Members are here 0
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

How to adjust the core LL(lower left )Co-ordinates-(Origin) to 00 ?

NAADHAN

Hi ,

      In mydesign a FloorPlan was completed and after that i saw that my core's LL(Lower Left) Co-ordinate was not at (0 0) but at some negative values (-x,-y).......

1)      Is there any way to correct this relatively so that all my macros and pins also get adjusted?????

2)     One way of doing it is to edit the co-ordinates in the def and reload-----> very tedious....... can this be done in an easier fashion using encounter (Version 7.1) ????

Thanks & Regards,

NAADHAN

Parents

  • Hi, DAADHAN,

    I don't know the command/procedure to achieve it inside FE. I usually carry out such kind of adjustment inside Virtuoso layout editor after I finished P&R and put my result (through DEF file) into Virtuoso Layout editor.  It is quite easy there:  Edit->Other->Move Origin will take care everything for you.

     Tongju

Reply

  • Hi, DAADHAN,

    I don't know the command/procedure to achieve it inside FE. I usually carry out such kind of adjustment inside Virtuoso layout editor after I finished P&R and put my result (through DEF file) into Virtuoso Layout editor.  It is quite easy there:  Edit->Other->Move Origin will take care everything for you.

     Tongju

Children
No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.