Stats

  • Locked Locked
  • Replies 3
  • Subscribers 90
  • Views 13119
  • Members are here 0
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Controlling the length of a wire for which it has to be taperred in width.

KVBABU

Hi friends,

 

           I am doing some experiments with mixed signal router in encounter. Here , i can taper a wide wire up to width equal to that of pin width to which it has to be connected. But, this tappering has been done for only small length of wire. I wanted to know whether, this tappering can be done at a larger length or not. Is so ,plz tell me the command.

 

 

Regards,

K.VISWANADH BABU

Parents

  •  Hai Kari,

     

    Thank you for your response . But, iam not using nanorouter to perform above said routing . So, i wanted to do the same using Mixed signal router in Encounter . So please suggest me a possible solution  using mixed signal router.

    Regards,

    K.Viswanadh Babu 

Reply

  •  Hai Kari,

     

    Thank you for your response . But, iam not using nanorouter to perform above said routing . So, i wanted to do the same using Mixed signal router in Encounter . So please suggest me a possible solution  using mixed signal router.

    Regards,

    K.Viswanadh Babu 

Children
No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.