Stats

  • Locked Locked
  • Replies 3
  • Subscribers 90
  • Views 1341
  • Members are here 0
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Determining timing margins for a process/design

Rajesh Vembu

How to arrive at a timing margin for a given process/design during implementation?

Are there some generic guidelines that can be followed?

Parents

  •  Kari,

    Thanks for your inputs.That was helpful.

    The other scaling factor normally used in the flow is for RCExtraction. Again this scaling factor could be different for each corner.

    Any thoughts/information on arriving at a RC scaling factor?

     

     

Reply

  •  Kari,

    Thanks for your inputs.That was helpful.

    The other scaling factor normally used in the flow is for RCExtraction. Again this scaling factor could be different for each corner.

    Any thoughts/information on arriving at a RC scaling factor?

     

     

Children
No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.