Stats

Locked Locked
Replies 1
Subscribers 91
Views 13299
Members are here 0

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

How to Match Routing wire length?

Sundarsan over 15 years ago

Hi,

I have a 8Bit Data path, each path has equal number of buffers.

The buffers are placed at equal distance, now when i route the signals, all the signals should have equal wire length.

The Signal in the same path and the signals in the other 8bit paths should have equal wire length after routing.

How to achive this using Nano route? Is there any special switch or setting to achieve this wire length matching?

Thanks in Advance,

Sundar

Parents

Kari over 15 years ago

Try routing these nets first. You can select the nets, run nanoRoute on selected nets only, then route the rest of the design.
Cancel
Vote Up 0 Vote Down

Cancel

Reply

Kari over 15 years ago

Try routing these nets first. You can select the nets, run nanoRoute on selected nets only, then route the rest of the design.
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.