Stats

  • Locked Locked
  • Replies 4
  • Subscribers 91
  • Views 3252
  • Members are here 0
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Cannot add TIEHI/TIELO cell successfully.

baixf
Hi, I ran the addTieHiLo command after placement, but no TIEH/TIEL cell was added. I found there were many net connecting with 1'b0 in the netlist, and I have run setTieHiLoMode -cell "TIEH TIEL" successfully. Can someone tell me what I should check for this problem? Thanks. Regards, Xuefei
Parents

  • Make sure the functionality of the tie high/low cells are defined properly in the timing lib. See the following solution for more details:

    http://support.cadence.com/wps/mypoc/cos?uri=deeplinkmin:ViewSolution;solutionNumber=11021248

    Regards,

    Brian

Reply

  • Make sure the functionality of the tie high/low cells are defined properly in the timing lib. See the following solution for more details:

    http://support.cadence.com/wps/mypoc/cos?uri=deeplinkmin:ViewSolution;solutionNumber=11021248

    Regards,

    Brian

Children
No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.