Stats

Locked Locked
Replies 4
Subscribers 91
Views 3331
Members are here 0

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Cannot add TIEHI/TIELO cell successfully.

Hi, I ran the addTieHiLo command after placement, but no TIEH/TIEL cell was added. I found there were many net connecting with 1'b0 in the netlist, and I have run setTieHiLoMode -cell "TIEH TIEL" successfully. Can someone tell me what I should check for this problem? Thanks. Regards, Xuefei

Parents

baixf over 14 years ago

I find that, only 1'b0 and 1'b1 in the top-level module can be tied to TIEHI/TIELO cells correctly. How to solve this problem? Thanks. Regards, Xuefei
Cancel
Vote Up 0 Vote Down

Cancel

Reply

baixf over 14 years ago

I find that, only 1'b0 and 1'b1 in the top-level module can be tied to TIEHI/TIELO cells correctly. How to solve this problem? Thanks. Regards, Xuefei
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.