Stats

  • Locked Locked
  • Replies 2
  • Subscribers 91
  • Views 2212
  • Members are here 0
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

"optDesign -preCTS" doesn't seem to be optimizing

Brannon

I'm trying to get velocity to optimize flop placement at the preCTS stage. The worst path is failing by -504ps, but if I check report_timing on the cycle before and the cycle after the failing path then I see both of these have considerable slack. When I run to later stages it does seem to move those flops around and largely fix the path--but I can't get it to fix those paths at preCTS stage.

I've tried 'optDesign -preCTS -incr', am I on the wrong track here?

Parents

  •  Thanks for the suggestion--I am indeed just trying to get it to place the flops more optimally (I haven't yet gotten to cycle stealing but that may be my next stop).

    I did an iteration of placeDesign -incremental and that helped but I looked and it still appeared it could do a better job. I did a couple more iterations and the worst path got better each time--but when I look at the worst path it still seemed that it could do much better by simply moving the flop further in one direction (I should mention that this is a wire dominated long route with multiple pipeline stages). I think this is the right track but I need to do more investigation.

    Thanks for pointing me in the right direction.

Reply

  •  Thanks for the suggestion--I am indeed just trying to get it to place the flops more optimally (I haven't yet gotten to cycle stealing but that may be my next stop).

    I did an iteration of placeDesign -incremental and that helped but I looked and it still appeared it could do a better job. I did a couple more iterations and the worst path got better each time--but when I look at the worst path it still seemed that it could do much better by simply moving the flop further in one direction (I should mention that this is a wire dominated long route with multiple pipeline stages). I think this is the right track but I need to do more investigation.

    Thanks for pointing me in the right direction.

Children
No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.