Stats

  • Locked Locked
  • Replies 6
  • Subscribers 92
  • Views 14513
  • Members are here 0
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

get outline of an commlex polygon with holes in it ?

The Consultant

is ther a way to get this outline( without the hole) 

 at the mement i use 

 

dbshape [dbshape $shapelist SIZE 1]  SIZE -1

 

to get ride of the holes, but i have to know the size of the holes to eleminate them.

 

regards

Parents
  • You are correct about the size operation (5 versus 10). However, the indent corner-case still occurs either way. The -d option forces dbShape into "DBU-coordinate" mode. I always specify it as a matter of habit so as to avoid any surprises.
Reply
  • You are correct about the size operation (5 versus 10). However, the indent corner-case still occurs either way. The -d option forces dbShape into "DBU-coordinate" mode. I always specify it as a matter of habit so as to avoid any surprises.
Children
No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.