Stats

  • Locked Locked
  • Replies 6
  • Subscribers 91
  • Views 15733
  • Members are here 0
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

nanoroute is not routing the design

Satendra

 I am using Cadence encounter edi10.1.I am able to run trial route successfully but whenever I run nanoroute for complete route, it removes all the trial routes but does not route anything. Basically after running nanoroute, I donot see any wires. 

Also when I looked at the log I say Nanoroute warnin (NRGR-22) Design is already detail routed.

I donot understand the issue. I checked all the rest of the log but could not find any thing. The total wire lengths on any metal is always 0.

Parents

  •  If there was a problem with the LEF syntax, you should report it to the library vendor. However, I can't think of any issues that would be caused by having version 5.5 instead of 5.6. Both are supported. Maybe something else was going on? Hard to say without looking at the data. Glad you got it working though!

Reply

  •  If there was a problem with the LEF syntax, you should report it to the library vendor. However, I can't think of any issues that would be caused by having version 5.5 instead of 5.6. Both are supported. Maybe something else was going on? Hard to say without looking at the data. Glad you got it working though!

Children
No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.