i am working with soc -encounter. while routing the design no violations were reported.but when verified with calibre -lvs its showing 4 incomplete nets. when checked for same nets in soc - E those are no connected/routed as required.what would be the reason & how to overcome such violations.
should these nets must be routed manually?
If you run Verify Connectivity in Encounter do these nets get reported as open? If they do, NanoRoute should route them assuming they are signal nets and they have not been excluded from routing (setAttribute -net netName -skip_routing true). If Verify Connectivity does not report the open then double check that the Verilog netlist defines the connectivity. If these are power/ground nets make sure globalNetConnect was run to define their connectivity and use power planning commands (addRing, addStripe, sroute) to route them.