Stats

  • Locked Locked
  • Replies 6
  • Subscribers 93
  • Views 15127
  • Members are here 0
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

incomplete nets

crystee

Hi all,

i am working with soc -encounter. while routing the design no violations were reported.
but when verified with calibre -lvs its showing 4 incomplete nets. when checked for same nets in soc - E those are no connected/routed as required.
what would be the reason & how to overcome such violations.

should these nets must be routed manually?

Thanks

Parents
  • crystee

    Verify Connectivity does not report any violations. When taken to calibre for LVS, these nets are reported as incomplete.

    When checked back in SoC-E these are not connected as intended.

    These are not power/ground nets.

Reply
  • crystee

    Verify Connectivity does not report any violations. When taken to calibre for LVS, these nets are reported as incomplete.

    When checked back in SoC-E these are not connected as intended.

    These are not power/ground nets.

Children
No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.