Stats

  • Locked Locked
  • Replies 5
  • Subscribers 91
  • Views 13889
  • Members are here 0
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

dbcommands

ArvindBezawada

Hi how to give adress of timing library and other valuies using this command

 dbNetEvalDelayAndTran netPtr timeArcPtr rise_delay(ns) rise_trans(ns) fall_delay(ns) fall_trans(ns)

 RightNow for reporting slew value of a net using "reportNet -net net_name"..This is taking longer time ..if it is a post route database it is

going for full chip extraction and then it is reporting so can we use any dbget command as alternative.......

Parents

  • Looks like ...When you load a fresh databsase and then use report_property then it will extract for full design.

    So First use report_timing and then use 'report_property' command.

    If you already have done report_timing on design then it will not extract again.

Reply

  • Looks like ...When you load a fresh databsase and then use report_property then it will extract for full design.

    So First use report_timing and then use 'report_property' command.

    If you already have done report_timing on design then it will not extract again.

Children
No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.