Stats

  • Locked Locked
  • Replies 6
  • Subscribers 91
  • Views 16528
  • Members are here 0
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Design hierarchy in Encounter

Aram Shahinyan

Dear Friends,

I have a block with the same structure (sub module) repeating many times. I have done manual placement & routing for one slice

and saved a design.

Now I need to instantiate and use a hand made slice many times (just like instantiating in layout editor)

Any ideas how I can do that?

Thanks in Advance,

Aram

Parents
  • It's been a while since I did this, but it might be that you don't uniquify the netlist if you are doing the master/clone flow. EDI should still accept the netlist, you may have warnings... if EDI really isn't accepting the netlist, then post back the exact error message and we'll see if we can figure out what's going on.
Reply
  • It's been a while since I did this, but it might be that you don't uniquify the netlist if you are doing the master/clone flow. EDI should still accept the netlist, you may have warnings... if EDI really isn't accepting the netlist, then post back the exact error message and we'll see if we can figure out what's going on.
Children
No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.