Stats

Locked Locked
Replies 3
Subscribers 91
Views 14155
Members are here 0

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Dummy Pins short errors IO corner pads

Hello,

I donot have much Experience in Place and route operation. The problem is that I have completed the place and routing of the core area as well as the IO pads. When I run DRC verify geometry I have no violations in the core area but in the Corner IO pads I get two short erros ( LeftBottom and Top right corner pads) in the dummy cell pins. It looks strange because even other two corners have the same dummy Pins but there are no short errors. The two Violations I am getting are

SHORT: Pin of Cell io_pad_left_bottom_corner & Blockage of Cell fillperi_S_0 ( M3 )

Bounds : ( 112.000, 1.900 ) ( 112.000, 2.100 )

SHORT: Pin of Cell io_pad_right_top_corner & Blockage of Cell fillperi_N_78 ( M3 )

Bounds : ( 1568.200, 1503.300 ) ( 1568.200, 1503.500 )

Can anyone please advise me on how to fix it.?

Parents

Kari over 12 years ago

can you post a picture of the violation? it's likely false, but hard to tell without a picture.
Cancel
Vote Up 0 Vote Down

Cancel

Reply

Kari over 12 years ago

can you post a picture of the violation? it's likely false, but hard to tell without a picture.
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.