Stats

  • Locked Locked
  • Replies 7
  • Subscribers 91
  • Views 15222
  • Members are here 0
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Nanoroute stops at Placement blockage

schnufff

In my design with 5 cores I have a Placement blockage around each core. This was suggested by Kari to stop sroute from connecting all follow pins together. But now CTS and also nanoroute stops routing all signal that run from the cores trough the blockage to the IO pads.

I though its a placement blockage and not a routing blockage. Trial route works fine, but produces a lot of violations. What can I do to

allow nanoroute to pass trough the placement blockage?

Thanks

Stefan

Parents

  •  I think it has to do with the following error:

    NET  $net is marked as fully connected but pin $pin of instance  $instance is not yet connected.

    This is repeated for all toplevel nets going to the IO cells. How can I reset these nets, so that they will be routed again?

     

    Stefan

Reply

  •  I think it has to do with the following error:

    NET  $net is marked as fully connected but pin $pin of instance  $instance is not yet connected.

    This is repeated for all toplevel nets going to the IO cells. How can I reset these nets, so that they will be routed again?

     

    Stefan

Children
No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.