Stats

  • Locked Locked
  • Replies 4
  • Subscribers 93
  • Views 18826
  • Members are here 0
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

How to place IO pins on internal wires and bumps in Innovus?

fieldy

Hi All,

I'm currently using Innovus to implement a full chip design that has flip chip bumps and has IO pad rings  on the periphery.

I would like to place IO pins of signals and power/ground directly on the bumps but struggling to find a good method to do so. 

I can't seem to find anything in the userguide to help me with this. I tried editPin but it will only allow pins to be on the side edges, which is not what I want.

I tried commands to move pins but it also won't let me move pins inside the die area, only letting me move pins to the edges.

Is there a good way to do this?

Parents
  • MikeLW
    editPin does seem to be mostly geared towards placing pins along the edges, but I think you can do what you want with -assign x y. Have you tried that?
Reply
  • MikeLW
    editPin does seem to be mostly geared towards placing pins along the edges, but I think you can do what you want with -assign x y. Have you tried that?
Children
No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.