Stats

Locked Locked
Replies 2
Subscribers 65
Views 13087
Members are here 0

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

mvl value duing @sim

Hi, what should be the output of the following code? sig_a is bind to wire "a" in verilog top file which has transitions "X -> Z -> 0 -> 1 -> Z -> 1". event a_c_e is change(smp.sig_a$)@sim; on a_c_e { print smp.sig_a.get_mvl(); }; The log file is showing "mvl_z" when the transition happens from "x" to "z". I am assuming that the specman should print "MVL_X" as the specman samples the previous value at change of signal not the updated value. Please correct me if i am wrong. Thanks

Parents

arjuny over 14 years ago

Hi Ravi,
I am sure because i have used "print sys.time" at every transition.
The trnasition from x->z happening at time "0" and the value it is printing is "MVL_Z" at that time.
Thanks.
Cancel
Vote Up 0 Vote Down

Cancel

Reply

arjuny over 14 years ago

Hi Ravi,
I am sure because i have used "print sys.time" at every transition.
The trnasition from x->z happening at time "0" and the value it is printing is "MVL_Z" at that time.
Thanks.
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.