Stats

  • Locked Locked
  • Replies 1
  • Subscribers 65
  • Views 1889
  • Members are here 0
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Prevent SimVision Schematic Viewer from Re-Zooming/Centering after tracing a signal?

BairStrokes

SimVision preferences have this option for the schematic tracer. Lets say I have a module port and wish to trace that  step by step (using double clicks). For small modules this works fine, but once you hit a large entity, the whole view re-zooms and you loose track where you actually left off.

I tried turning above option on and off, but it is always unsatifying. With the option it always zooms in very close, without it you  sometimes get thrown back to the 10000ft-view when a large module is added to the viewport.

I just want the tool to retain my zooming level and position and just add the traced connection, which I can then follow.

I didn't think that this was such a 'out of this world request' but I cannot seem to find the setting that does this. (basically I'm asking: do nothing but add the next stage of the traced wire)

Any help is appreciated!

Parents Reply Children
No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.