Stats

Locked Locked
Replies 2
Subscribers 63
Views 14025
Members are here 0

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Timing analysis in RTL Compiler

Hi,

I want to look at the net arc delay for a given from_pin and to_pin on a net. Is there a command that can get me that? I tried "report net_delay_calculation" but it says that this command is not supported on physical nets.

Ankur

Parents

TungVo over 7 years ago

Hi Ankur,

You can set global report_timing_format {hbin arc net delay cell slew} then report_timing -from <from_pin> -to <pin_to>. The table report will show all information for you.

Hope it can help you

Best,

TungVo
Cancel
Vote Up 0 Vote Down

Cancel
as90 over 7 years ago in reply to TungVo

Thank you Tung Vo. I'll try it later.
Cancel
Vote Up 0 Vote Down

Cancel

Reply

as90 over 7 years ago in reply to TungVo

Thank you Tung Vo. I'll try it later.
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.