Stats

  • Locked Locked
  • Replies 1
  • Subscribers 64
  • Views 13213
  • Members are here 0
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Monto carlo simulation

Custom IC Desi
 i am using IC 6.1.5-64b  with foundary file of UMC-180nm. i want to use monto carlo mis match simulation to find the gain of folded cascode op amp.

in ADE-Xl after  setup the test ,i include  montocarlo model file(with extension of mc-corner.scs)   after that l loaded the saved state and i also defined the variable sigma value of 3.

after i click on the  run button it showing finished .but when i click on the plot button it shows nothing...

in cds.log file i found the following information

You must openResults() on a valid psf directory before

using this command. Make sure your openResults() worked.

Use ocnHelp('results) for more information.
Parents

  • Are you actually setting up any output expressions? You won't get histograms unless you're calculating some scalar values.

    Perhaps you can upload a screenshot of your output pane in ADE XL? (Use the Options tab when replying on the forum).

    Regards,

    Andrew.

Reply

  • Are you actually setting up any output expressions? You won't get histograms unless you're calculating some scalar values.

    Perhaps you can upload a screenshot of your output pane in ADE XL? (Use the Options tab when replying on the forum).

    Regards,

    Andrew.

Children
No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.