Stats

  • Locked Locked
  • Replies 6
  • Subscribers 63
  • Views 1609
  • Members are here 0
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

simvision analog variables and signals display issue

mxgong

Hi,

I am running ams simulation in the interactive mode.

However, the simulation has gone through, but I can only observe the digital signals. All analog signals (including inputs and outputs) and variables within the analog begin block are showing no value in the waveform window.

Here vin[8] is a net in the testbench schematic. triggers_out[x] are digital signals. Ceq is a real number inside the analog begin block.

When I stop the simulation and open result browser, the signals in schematics are saved there.

Thanks

Minxiang

Parents
  • Andrew Beckett

    Minxiang,

    Which XCELIUM and SPECTRE sub-versions are you using? (these will be reported in the simulation log)

    Andrew

Reply
  • Andrew Beckett

    Minxiang,

    Which XCELIUM and SPECTRE sub-versions are you using? (these will be reported in the simulation log)

    Andrew

Children
  • mxgong
    in reply to Andrew Beckett

    Hi Andrew,

    Thanks for the quick reply.

    the XCELIUM version is 23.03-a071 64b

    the spectre version is 24.1.0.314.isr6 64b

    Thanks

    Minxiang

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.