Stats

  • State Not Answered
  • Replies 2
  • Subscribers 161
  • Views 8869
  • Members are here 0
More Content

Interactive delay tuning help

coronas

I created a match group of nets in constraint manager -> relative delay section

When I use the delay tune command this indicator pop-up 

 

I cannot understand the meaning of these numbers and bars:

-totE is similar to total etching value but in constraint manager it says 124mm not 127mm, there is always discrepancies

-RDly shows two numbers, a negative and a positive one, what does it mean?

what is the measure unit of these numbers? 

can I change the numbers to be shown?

Thanks

Parents Reply Children
No Data
Cadence Guidelines

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.