• Skip to main content
  • Skip to search
  • Skip to footer
Cadence Home
  • This search text may be transcribed, used, stored, or accessed by our third-party service providers per our Cookie Policy and Privacy Policy.

  • This search text may be transcribed, used, stored, or accessed by our third-party service providers per our Cookie Policy and Privacy Policy.

  • Site
  • Community Search
  • User
Forum - Thread List
  • Discussion

    REG:DIFFERENTIAL PAIR SPACING VIOLATION

    504 views
    0 replies
    Started over 16 years ago
    by girish
  • Discussion

    reference designator in schematic and symbol Locked

    14871 views
    1 reply
    Latest over 16 years ago
    by redwire
  • Discussion

    Adding a hole inside a board Locked

    14433 views
    1 reply
    Latest over 16 years ago
    by oldmouldy
  • Discussion

    footprints ok in component browser but not on layout Locked

    14345 views
    1 reply
    Latest over 16 years ago
    by hpattie
  • Discussion

    Text Legend Locked

    13916 views
    1 reply
    Latest over 16 years ago
    by Goblin59
  • Discussion

    Moving symbols with traces Locked

    15050 views
    1 reply
    Latest over 16 years ago
    by tomoo
  • Discussion

    Setting up blind/buried vias, via-in-pad Locked

    1423 views
    1 reply
    Latest over 16 years ago
    by girish
  • Discussion

    shape inside a symbol Locked

    13737 views
    1 reply
    Latest over 16 years ago
    by Goblin59
  • Discussion

    Interactive vs. General mode and how to setup

    16050 views
    2 replies
    Latest over 16 years ago
    by Pieman
  • Discussion

    Copper over footprint pins Locked

    20096 views
    8 replies
    Latest over 16 years ago
    by Olek
  • Discussion

    Orcad 16.3 Demo problem Locked

    16377 views
    2 replies
    Latest over 16 years ago
    by BobH99
  • Discussion

    What are commands like: _DTL_UTLIS_get_temp

    821 views
    1 reply
    Latest over 16 years ago
    by eDave
  • Discussion

    Using Height Property from Orcad Capture Locked

    18961 views
    2 replies
    Latest over 16 years ago
    by fxffxf
  • Discussion

    How to set the spacing between planes/clines to the outline Locked

    1915 views
    4 replies
    Latest over 16 years ago
    by RING
  • Discussion

    Convert a line to a cline Locked

    18416 views
    1 reply
    Latest over 16 years ago
    by Ejlersen
<>

© 2026 Cadence Design Systems, Inc. All Rights Reserved.

  • Terms of Use
  • Privacy
  • Cookie Policy
  • US Trademarks
  • Do Not Sell or Share My Personal Information