• Skip to main content
  • Skip to search
  • Skip to footer
Cadence Home
  • This search text may be transcribed, used, stored, or accessed by our third-party service providers per our Cookie Policy and Privacy Policy.

  1. Community Forums
  2. Computational Fluid Dynamics

Computational Fluid Dynamics

CDNS Forum CFD Categories

AutoMesh

Flow

Installation

Marine

OpenLabs

Optimization

Fidelity Pointwise

Results analysis

Turbo

Online CFD Course

Feedback, Suggestions, and Questions

Provide feedback on the forums or any other part of the site. Questions and suggestions welcome.

  • This search text may be transcribed, used, stored, or accessed by our third-party service providers per our Cookie Policy and Privacy Policy.

Forum - Thread List

Latest Posts

  • Discussion

    FINE Design 3D .FD3 Error

    Category: Optimization

    By JosephSmith

    •

    updated over 2 years ago by JosephSmith

    8 replies • 9601 views
  • Answered

    Convergence not reached/ k epsilon

    Category: Turbo

    By sriluta

    •

    updated over 2 years ago by sriluta

    1 replies • 2134 views
  • Answered

    boundary condition (inlet)

    Category: Turbo

    By sriluta

    •

    updated over 2 years ago by sriluta

    3 replies • 2247 views
  • Answered

    Unable start software.

    Category: Online CFD Course

    By SURYA45

    •

    updated over 2 years ago by Manuel NIB

    6 replies • 5280 views
  • Answered

    Probe creation

    Category: Online CFD Course

    By carll

    •

    updated over 2 years ago by carll

    2 replies • 2558 views
  • Answered

    CFD Course _ ERROR: residual of Mass is Not A Number: the solver has been stopped

    Category: Online CFD Course

    By NicoBu

    •

    updated over 2 years ago by Manuel NIB

    3 replies • 3455 views
  • Answered

    Epsilon in initial solution and boundary condition

    Category: Online CFD Course

    By MaxiWei

    •

    updated over 2 years ago by Manuel NIB

    1 replies • 2516 views
  • Answered

    Mesh configuration in Omnis/turbomachinery

    Category: Turbo

    By sriluta

    •

    updated over 2 years ago by sriluta

    10 replies • 5143 views
  • Answered

    Extended duct issue

    Category: Online CFD Course

    By Mick2112

    •

    updated over 2 years ago by Mick2112

    2 replies • 2553 views
  • Answered

    Problems with the Data; can not open Elbow duct

    Category: Online CFD Course

    By DilekY

    •

    updated over 2 years ago by Manuel NIB

    1 replies • 1879 views
<>

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.

© 2025 Cadence Design Systems, Inc. All Rights Reserved.

  • Terms of Use
  • Privacy
  • Cookie Policy
  • US Trademarks
  • Do Not Sell or Share My Personal Information