• Skip to main content
  • Skip to search
  • Skip to footer
Cadence Home
  • This search text may be transcribed, used, stored, or accessed by our third-party service providers per our Cookie Policy and Privacy Policy.

  • This search text may be transcribed, used, stored, or accessed by our third-party service providers per our Cookie Policy and Privacy Policy.

  • Site
  • Community Search
  • User
Forum - Thread List
  • Discussion

    How do you manage variations in your BOM (Bill of Material)?

    6084 views
    2 replies
    Latest over 2 years ago
    by Minet
  • Discussion

    Right Angle Route/Slot in Padstack?

    6930 views
    9 replies
    Latest over 2 years ago
    by jc teyssier
  • Discussion

    How to print report to pdf

    9024 views
    3 replies
    Latest over 2 years ago
    by Tolo1996
  • Suggested Answer

    Drill hole size vs finished hole size chart 0

    11239 views
    4 replies
    Latest over 2 years ago
    by PCB6453
  • Discussion

    PSpice - Tip of the Week: How to enable non-dockable(old) cursor window.

    1226 views
    0 replies
    Started over 2 years ago
    by DesignTech
  • Not Answered

    Checkbox in the FORM in the OrCAD PCB Designer 0

    7517 views
    2 replies
    Latest over 2 years ago
    by JuriV
  • Discussion

    AutosilkUtils in 17.2

    24922 views
    19 replies
    Latest over 2 years ago
    by JamesLin
  • Answered

    Global Saving of Added Subclasses to Visibility Pane? 0

    10563 views
    2 replies
    Latest over 2 years ago
    by GilMay2
  • Suggested Answer

    What is the size/ block range for Ref-Des text on Silk screen? 0

    8229 views
    2 replies
    Latest over 2 years ago
    by aniju
  • Discussion

    How do you view the updated list of parts used in the design?

    4608 views
    0 replies
    Started over 2 years ago
    by Krishnadas
  • Answered

    bring CIS components to OrCad capture, error ORCAP-2396 +1

    7425 views
    4 replies
    Latest over 2 years ago
    by Yishai123
  • Discussion

    Access to part datasheet on the fly with built-in component search

    745 views
    0 replies
    Started over 2 years ago
    by DesignTech
  • Answered

    Create Thru Pin with BEGIN LAYER/END LAYER names using SKILL 0

    3994 views
    4 replies
    Latest over 2 years ago
    by mahimag
  • Answered

    Prevent Allegro from declaring the path of the project file in the .art deliverables. 0

    8424 views
    4 replies
    Latest over 3 years ago
    by Tim Nagi
  • Not Answered

    UCC25800 0

    5559 views
    2 replies
    Latest over 3 years ago
    by TechiEE12
<>

© 2026 Cadence Design Systems, Inc. All Rights Reserved.

  • Terms of Use
  • Privacy
  • Cookie Policy
  • US Trademarks
  • Do Not Sell or Share My Personal Information