• Skip to main content
  • Skip to search
  • Skip to footer
Cadence Home
  • This search text may be transcribed, used, stored, or accessed by our third-party service providers per our Cookie Policy and Privacy Policy.

  • This search text may be transcribed, used, stored, or accessed by our third-party service providers per our Cookie Policy and Privacy Policy.

  • Site
  • Community Search
  • User
Forum - Thread List
  • Not Answered

    Simulation of MOSFET in PSpice 0

    7160 views
    3 replies
    Latest over 2 years ago
    by HIMS
  • Suggested Answer

    Constrain manager Required and Actual Values 0

    6675 views
    4 replies
    Latest over 2 years ago
    by TCHA
  • Not Answered

    When trying to use the fuse for overcurrent protection, I keep running into errors where close to the current limit it will cut off the supply when current should still be flowing. Is there a way to stop this? 0

    6911 views
    6 replies
    Latest over 2 years ago
    by HIMS
  • Not Answered

    Problem when I run the unencrypted library file 0

    7550 views
    7 replies
    Latest over 2 years ago
    by HIMS
  • Not Answered

    Create and share a workspace in OrCAD X Capture CIS 0

    4332 views
    0 replies
    Started over 2 years ago
    by DesignTech
  • Answered

    How to assign different values to various components in Pspice 0

    5711 views
    4 replies
    Latest over 2 years ago
    by MujikaJulen
  • Not Answered

    For AC simulation, it starts to run simulation until 100%, but I cannot see the graph. 0

    3916 views
    1 reply
    Latest over 2 years ago
    by AyushD
  • Answered

    What is the difference between a "project" and a "design"? 0

    5209 views
    6 replies
    Latest over 2 years ago
    by Muhyun
  • Suggested Answer

    component dxf to footprint 0

    6145 views
    3 replies
    Latest over 2 years ago
    by masamasa
  • Discussion

    Unveiling the power of PCB Design for Manufacturing checks in Allegro X and OrCAD X

    6094 views
    0 replies
    Started over 2 years ago
    by PCBTech
  • Discussion

    How to reuse device files for existing components

    5709 views
    0 replies
    Started over 2 years ago
    by PCBTech
  • Discussion

    Modeling a frequency dependent Inductor in PSpice

    4477 views
    0 replies
    Started over 2 years ago
    by DesignTech
  • Suggested Answer

    Is it correct to route connections under the component? 0

    6442 views
    2 replies
    Latest over 2 years ago
    by TCHA
  • Answered

    Multiple touch points for bond wires on a die pin +1

    7800 views
    4 replies
    Latest over 2 years ago
    by TCHA
  • Discussion

    What is Microvia Slot and how it can be added using Padstack Editor?

    5277 views
    0 replies
    Started over 2 years ago
    by PCBTech
<>

© 2025 Cadence Design Systems, Inc. All Rights Reserved.

  • Terms of Use
  • Privacy
  • Cookie Policy
  • US Trademarks
  • Do Not Sell or Share My Personal Information