• Skip to main content
  • Skip to search
  • Skip to footer
Cadence Home
  • This search text may be transcribed, used, stored, or accessed by our third-party service providers per our Cookie Policy and Privacy Policy.

  • This search text may be transcribed, used, stored, or accessed by our third-party service providers per our Cookie Policy and Privacy Policy.

  • Site
  • Community Search
  • User
Forum - Thread List
  • Discussion

    Can the Insert Image be set to higher resolution? Locked

    13684 views
    0 replies
    Started over 14 years ago
    by DaleinAZ
  • Discussion

    numbering the pins , confused Locked

    12861 views
    0 replies
    Started over 14 years ago
    by Mohad
  • Discussion

    VHDL to schematic Locked

    13578 views
    0 replies
    Started over 14 years ago
    by DaveAJohnson
  • Discussion

    skill code required Locked

    12745 views
    1 reply
    Latest over 14 years ago
    by Khurana
  • Discussion

    Extra component on board Locked

    13673 views
    3 replies
    Latest over 14 years ago
    by Randy R
  • Discussion

    DxDesigner schematic to allegro netlist .... Locked

    14794 views
    1 reply
    Latest over 14 years ago
    by luvishis
  • Discussion

    How to convert Orcad Layout (.MAX) to PCB Editor (.brd) ? Locked

    17961 views
    2 replies
    Latest over 14 years ago
    by Raam
  • Discussion

    OrCAD Capture - cannot set default fonts Locked

    6823 views
    2 replies
    Latest over 14 years ago
    by Allan M
  • Discussion

    How to best handle component fiducials? Locked

    14538 views
    4 replies
    Latest over 14 years ago
    by EvanShultz
  • Discussion

    Reg:Shortcut key's to switch between Film layers Locked

    7691 views
    6 replies
    Latest over 14 years ago
    by C Shiva
  • Discussion

    Clearances in positive plane shapes. Locked

    12845 views
    0 replies
    Started over 14 years ago
    by mrbudd
  • Discussion

    Replace Obsolete Symbols Locked

    13284 views
    1 reply
    Latest over 14 years ago
    by Cadpro2K
  • Discussion

    Drill holes drifting off center Locked

    13190 views
    1 reply
    Latest over 14 years ago
    by Bitmap
  • Discussion

    DRA rule sets Locked

    12695 views
    0 replies
    Started over 14 years ago
    by HWDesigner
  • Discussion

    Allegro 'show measure' units Locked

    14941 views
    3 replies
    Latest over 14 years ago
    by EvanShultz
<>

© 2025 Cadence Design Systems, Inc. All Rights Reserved.

  • Terms of Use
  • Privacy
  • Cookie Policy
  • US Trademarks
  • Do Not Sell or Share My Personal Information