• Discussion

  Same net spacing DRC error handling

  11416 views
  2 replies
  Latest over 4 years ago
  by ichliebedich
• Not Answered

  How to export a ISCF (Intel Schematic Checking Format) file from 17.2 Cadence/Allegro PCB Designer ? 0

  7282 views
  8 replies
  Latest over 4 years ago
  by luvishis
• Discussion

  Updating the poly pitch of a transistor Locked

  10322 views
  0 replies
  Started over 4 years ago
  by MSP032
• Discussion

  Route From Target Hot Key

  10573 views
  3 replies
  Latest over 4 years ago
  by excellon1
• Discussion

  ADE Assembler Message 1921 - When running multiple sweep points Locked

  8695 views
  6 replies
  Latest over 4 years ago
  by Christos Skoufis
• Discussion

  recognize paths with metal jumps using DIVA Locked

  10393 views
  1 reply
  Latest over 4 years ago
  by Andrew Beckett
• Discussion

  What is the difference between metal usages and film area in PCB Editor? Locked

  10431 views
  0 replies
  Started over 4 years ago
  by hetban
• Discussion

  How to remove random Items associating on symbols

  11195 views
  4 replies
  Latest over 4 years ago
  by tmd63
• Discussion

  Mu and Mu_prime in S parameter analysis Locked

  17061 views
  4 replies
  Latest over 4 years ago
  by Frank Wiedmann
• Discussion

  How to flatten Pcell in schematic Locked

  13626 views
  3 replies
  Latest over 4 years ago
  by Andrew Beckett
• Discussion

  when I run CM Rule, program is down at OrCAD 16.6 latest hotfix (S115) Locked

  10036 views
  0 replies
  Started over 4 years ago
  by ichliebedich
• Discussion

  How can you move/stretch schematic wires WITHOUT Virtuoso rerouting everything and making a mess? Locked

  5596 views
  2 replies
  Latest over 4 years ago
  by mmsaad66
• Discussion

  Truncate a List

  13743 views
  4 replies
  Latest over 4 years ago
  by eDave
• Discussion

  Transient stop time for specified number of clocks Locked

  15269 views
  7 replies
  Latest over 4 years ago
  by Andrew Beckett
• Discussion

  How to flatten GDS by stream out or Command Locked

  11518 views
  2 replies
  Latest over 4 years ago
  by MollyMeow