• Skip to main content
  • Skip to search
  • Skip to footer
Cadence Home
  • This search text may be transcribed, used, stored, or accessed by our third-party service providers per our Cookie Policy and Privacy Policy.

  • This search text may be transcribed, used, stored, or accessed by our third-party service providers per our Cookie Policy and Privacy Policy.

  • Site
  • Community Search
  • User
Forum - Thread List
  • Discussion

    estimate inductance of PCB trace? Locked

    18610 views
    4 replies
    Latest over 10 years ago
    by doginwater
  • Discussion

    Place bounds in Gerbers Locked

    14870 views
    3 replies
    Latest over 10 years ago
    by redwire
  • Discussion

    Distinguish net names Locked

    14666 views
    3 replies
    Latest over 10 years ago
    by shangwu
  • Discussion

    Extracting Net properties from Orcad schematic. Locked

    14588 views
    0 replies
    Started over 10 years ago
    by Roger G
  • Discussion

    SKILL function to 'get' the DRC Marker Size set by user in 'Design Parameters' window

    2632 views
    3 replies
    Latest over 10 years ago
    by B Bruekers
  • Discussion

    BOM HDL - Parts of Same Vendor Part Number not Grouped Locked

    582 views
    0 replies
    Started over 10 years ago
    by maberu
  • Discussion

    non plated mechanical pin no clearance to copper ? Locked

    14404 views
    1 reply
    Latest over 10 years ago
    by Lennie
  • Discussion

    capture output window disappeared? Locked

    17818 views
    2 replies
    Latest over 10 years ago
    by doginwater
  • Discussion

    I can't run a simulation, errors occur Locked

    4940 views
    2 replies
    Latest over 10 years ago
    by Alexandros81
  • Discussion

    routing thru pins with no nets. Locked

    14073 views
    2 replies
    Latest over 10 years ago
    by techk
  • Discussion

    How to route SDR SDRAM ? Locked

    13993 views
    0 replies
    Started over 10 years ago
    by kiprik123
  • Discussion

    6 layer board with via, how to specify NC drill file Locked

    14091 views
    1 reply
    Latest over 10 years ago
    by redwire
  • Discussion

    How to place heterogeneous parts in two same hierarchy bolcks(occurrence)? Locked

    7998 views
    9 replies
    Latest over 10 years ago
    by George Dishman
  • Discussion

    convert a line to an arc or shape line to arc. Locked

    21677 views
    6 replies
    Latest over 10 years ago
    by Lennie
  • Discussion

    Database Setup Locked

    14461 views
    1 reply
    Latest over 10 years ago
    by steve
<>

© 2026 Cadence Design Systems, Inc. All Rights Reserved.

  • Terms of Use
  • Privacy
  • Cookie Policy
  • US Trademarks
  • Do Not Sell or Share My Personal Information